20 Chapter 1
Connecting to a TV Antenna or Cable
Connecting an FM Radio Antenna
Selecting an A/V Input Source
After connecting a display device to the system, you can run Media Center to setup the display device’s input
signal.
1. Open Media Center. See “Opening Media Center”.
2. Select My TV > More TV.
3. AV-input Source Selection will show on the right side of the screen, choose an input source from the following
options:
• AV1/SCART1 - Video
• AV1/SCART1 - S-Video
• AV2 - Video
• AV2 - S-Video
• AV3/SCART2 - Video
• AV3/SCART2 - S-Video
A
A
To Next Page
Loading...
