52 Chapter 3
Reassembly Procedure
Aspire M1610/Veriton M261 Reassembly
NOTE: The only physical difference between the two models is the front bezel as shown in the procedures.
1. Install the Power-supply by fitting the Power-supply into the chassis, then fasten the four screws shown.
2. Install the mainboard by aligning the I/O connector with the chassis, making sure the M/B VIA hole fits the
oriented STAND OFF on the chassis. Insert the 6 screws to hold the M/B in place as shown.
3. Install the CPU.
To Next Page
Loading...
