System Utilities 2-16
DOS Flash Utility
NOTE:
Plug the AC power adaptor to a power source before performing the DOS Flash Utility.
Perform the following to use the DOS Flash Utility:
1. Copy Flash.BAT to the USB HDD.
2. Press F2 during boot to enter the BIOS Setup Utility.
3. Select Boot menu to modify the boot priority order.
4. Move the USB HDD to position 1 (refer to Boot on page 2-12).
Figure 2:15. Changing the BIOS Boot Priority Order
5. Insert the USB HDD and reboot the computer.
6. Enter the BIOS folder.
7. At the command prompt, type BIOS.bat and press Enter to update BIOS.
Figure 2:16. Executing BIOS.BAT
IMPORTANT:
• Ensure the AC power adaptor is connected to the power source.
• Do not disconnect the AC power adapter.
F9 Setup Defaults
F10 Save and Exit
F1
Esc
Help
Exit
Select Item
Select Menu
Enter
F5/F6
Select Sub-Menu
Change Values
InsydeH20 Setup Utility Rev. 3.7
Main
Item Specific Help
Use <ʅ> or <ʆ> to select a device, then
press <F5> to move it down the list, or
<F6> to move it up the list. Press <Esc>
to escape the menu
Boot priority order:
1. Network Boot : BRCM MBA Slot 0200 v15.0.11
2. USB FDD :
3. HDD0 : TOSHIBA MK7559GSXP
4. USB HDD :
5. USB CDROM :
6. ATAPI CDROM : MATSHITABD-CMB UJ160
AdvancedInformation Security ExitBootPower
To Next Page
Loading...
