Service and Maintenance 3-3
Service and Maintenance
Introduction
This chapter contains general information about the notebook, a list of tools needed to perform the
required maintenance and step by step procedures on how to remove and install components from
the notebook computer.
Recommended Equipment
The following tools are required to perform maintenance on the notebook:
• Wrist grounding strap and conductive mat
• Flat screwdriver
• Philips screwdrivers
• Pointed plastic pry or similar object
Screw Name Screw Type Quantity
M 2.5 x 4.0 15
M 2.45 x 8.0 21
M 2.0 x 2.5 3
M 2.0 x 3.0 11
M 2.0 x 5.0 7
M 3.0 x 3.0 4
M 2.0 x 3.0 4
M 1.6 x 3.0 5
M 1.6 x 2.0 2
M 2.5 x 3.2 4
To Next Page
Loading...
