Machine Maintenance 3-31
Removing the Mainboard 0
1. Perform the “Removing the Palmrest Module/Upper Case” procedure described on
page 3-19.
2. Perform the “Removing the ODD Module” procedure described on page 3-15.
3. Perform the “Removing the SATA Board” procedure described on page 3-27.
4. Perform the “Removing the WLAN Module” procedure described on page 3-29.
5. Turn the computer over to access the base side of the lower case assembly.
6. Disconnect the speaker cable from the mainboard.
Figure 3-40. Speaker Cable
7. Turn the computer over to access the mainboard.
8. Release the LCD cable from the adhesive tape securing it.
Figure 3-41. LCD Cable Adhesive Tape
To Next Page
Loading...
