English
2
Attaching/ Removing the base
Install: Align the base with the stand and push the base towards the top of
the monitor, and then rotate the base clockwise. Tighten the screw clockwise.
Remove: Press release bottom and reverse the steps to remove the base.
Warning:
• actionsBelow are not allowed while moving and walking: high adjustment, tilt,
swivel and pivot because of safety requirement.
• To prevent fragile panel broken, when moving and disassembling the product , it
must pull the monitor head to the top at first and place the horizontal direction on
the table.
To Next Page
Loading...
