Acer H233H - Page 36

- 36 -
Figure-1: Preset Timing modes list
Mode
Resolution
(active dot)
Resolution
(total dot)
Horizontal
Frequency (KHz)
Vertical
Frequency (Hz)
Nominal Pixel
Clock (MHz)
640x480@60Hz 800 x 525 31.469 59.941 25.175
640x480@72Hz 832 x 520 37.861 72.809 31.500
MAC 640x480@66.66Hz 864x525 35 66.66 30.24
VESA 720x400@70Hz 900x449 31.469 70.087 28.322
800x600@56Hz 1024 x 625 35.156 56.250 36.000
800x600@60Hz 1056 x 628 37.879 60.317 40.000
SVGA
800x600@72Hz 1040 x 666 48.077 72.188 50.000
1024x600@60Hz 1312x622 37.320 60.000 48.964
1024x768@60Hz 1344x806 48.363 60.004 65.000
XGA
1024x768@70Hz 1328x806 56.476 70.069 75.000
1152x864@75Hz 1600x900 67.5 75 108
VESA
1280x960@60Hz 1800x1000 60 60 108
SXGA 1280x1024@60Hz 1688x1066 63.981 60.020 108.000
VESA
1280x720@60Hz 1650x750 44.955 59.940 74.176
1280x800@60Hz 1680x831 49.702 59.810 83.500
WXGA
1360x768@60Hz 1792x795 47.712 60.015 85.500
WXGA+ 1440x900@60Hz 1904x931 55.935 59.887 106.500
WSXGA+ 1680x1050@60Hz 2240*1089 65.290 59.954 146.250
1600x1200@60Hz 2160x1250 75.000 60.000 162.000
1920x1080@60Hz 2576x1120 67.158 59.963 173.000
1920x1080@60Hz 2200x1125 67.500 60.000 148.500
UXGA
1920x1080@60Hz 2080x1111 66.587 59.934 138.500
Note:
1. Show “Input Not Supported” warning message.
When Vertical Frequency is over 76Hz or under 56Hz, the display is Black and showing “Input Not
Supported” warning message. (Some video timings are except for PAL, 50Hz signals.)
2. If Hf /Vf is set in the range of 31KHz~83KHz and 56Hz ~76Hz (not including some video timing), and
Pixel Clock is set in the range of 25.175MHz~173MHz(DVI and HDMI input port 165MHz for Single-
Link), but is not the above Resolution, then it will display the nearest mode.
3. When digital input 1680x1050@75Hz and 1920x1080@60Hz_CVT, because of TMDS Pixel Clock is
setting in the range of 25MHz~165MHz, the source may use Dual-Link signal to transmit the timing.
This model can only support Single-Link to receive the information of half-of- Dual-Link, the display
may be abnormal.