Acer NITRO VG2 VG272U

EN-18
Adjusting the System
1. Press the MENU key to open the OSD.
2. Using the Navi/OK button, select System from the OSD. Then navigate to
the setting you wish to adjust.
3. Use the Navi/OK button to select the setting.
4. Input: Select the source from an available input source.
5. Auto Source: Automatically searches for available input sources.
6. DP Format: You can select which DP format you are using. The default is
set at DP1.4.
7. Hot Key Assignment: Select the function of Hot Key 1 or Hot Key 2.
8. Wide Mode: You can select which screen aspect you are using. The
options are Full, Aspect and 1:1.
9. DDC/CI: Allows the monitor settings to be set through the software on
the PC.
10. HDMI Black Level: You can select the level of blackness under HDMI
source. The options are Normal and Low.
11. Quick Start Mode: Enable monitor rapidly.
Note: DDC/CI, short for Display Data Channel/Command Interface,
which allows monitor controls to be sent via software.