25
English
Appendices
Troubleshooting
If you experience a problem with your Acer projector, refer to the following
troubleshooting guide. If the problem persists, please contact your local reseller
or service center.
Image Problems and Solutions
# Problem Solution
1 No image appears
onscreen
• Connected as described in the "Installation" section.
• Ensure none of the connector pins are bent or
broken.
• Check if the projection lamp has been securely
installed. Please refer to the "Replacing the Lamp"
section.
• Make sure you have slid on the lens door and the
projector is turned on.
2 Partial, scrolling
or incorrectly
displayed
image(For PC
(Windows 95/98/
2000/XP))
• Press "RESYNC" on the remote control or control
panel.
• For an incorrectly displayed image:
• Open "My Computer", open the "Control
Panel", and then double-click the "Display"
icon.
• Select the "Settings" tab.
• Verify that your display resolution setting is
lower than or equal to UXGA (1680 x 1050)
(P5260E/P5260EP series) or WXGA+ (1400 x
900) (P1165E/P1165EP series).
• Click the "Advanced Properties" button.
If the problem still appears, change the monitor display
you are using and follow the steps below:
• Verify that the resolution setting is lower than
or equal to UXGA (1680 x 1050) (P5260E/
P5260EP series) or WXGA+ (1400 x 900)
(P1165E/P1165EP series).
• Click the "Change" button under the
"Monitor" tab.
• Click "Show all devices". Next, select "Standard
monitor types" under the SP box, and choose
the resolution mode you need under the
"Models" box.
• Verify that the resolution setting of the
monitor display is lower than or equal to UXGA
(1680 x 1050) (P5260E/P5260EP series) or
WXGA+ (1400 x 900) (P1165E/P1165EP series).
To Next Page
Loading...
Need help?
General
