Acer P243W - Page 14

Plug 6 lamp cables to the connectors of inverter
board.
Take lamp cables out from the holes shown as the
photo.
Turn the monitor faced down and put it on the
bracket chassis module till both parts firmly
Connect FFC cable to LCD panel. There are
two locks over here when plugging in should be
noticed
Connect the FFC cable to the connector of the LCD
panel.
Connect cable into inverter board(CN001)
Take an inverter shielding bracket to cover the
inverter board
Use a Phillips-head screwdriver screwed the
No.1~6 screws till that inverter shielding bracket
and bracket chassis base firmly attached.
(No1~6 screw size=M3x4; Torque=9~10KGFxCM).
4. Assembly and Disassembly Procedures (continued)
S11
S10
S7
S9
S8
Angel < 5 degrees
Plug in parallel direction
1
2
3
4
5
6
CNOO1
13
Go to cover page
ACER P243W