... English
11
Powering On/Off the Projector
Powering On the Projector
1. Remove the lens cap.
2. Ensure that the power cord and signal cable are securely connected.
The Power LED will flash blue.
3. Turn on the lamp by pressing “
” button on the control panel.
1
And the Power LED will turn steady blue.
4. Turn on your source (computer, notebook, video player ,etc.).
The projector will detect your source automatically.
the screen displays “No Signal”, please make sure the signal
cables are securely connected.
If you connect multiple sources at the same time, using the
“Source” button on the remote control or control panel to
switch.
Installation
Turn on the
projector first and
then the signal
sources.
Power
N
OTE
To Next Page
Loading...
