2
Power saving
The monitor will be switched to "power saving" mode by the control signal from the display
controller, as indicated by the orange-colored power LED.
The power saving mode will be kept until a control signal has been detected or the keyboard
or mouse is activated. The recovery time from "power saving" mode back to "on" is around 3
seconds.
Display Data Channel (DDC)
To make installation easier, so long as your system supports the DDC protocol, the monitor is
able to plug-and-play. The DDC is a communication protocol through which the monitor
automatically informs the host system about its capabilities; for example, supported
resolutions and corresponding timing. The monitor supports the DDC2B standard.
Model LED light
On
White
Power saving
orange
English
To Next Page
Loading...
