31
4.8 After writing the EDID pass, you must read the EDID to ensure the EDID data had been write into the monitor.
Choose one of the port to read.
1. If it appears all “00” when read the EDID data,you need reconnect the ISP tool or install the the driver of the ISP tool
again.
2. If it appears all “FF”, it shows that the EDID data of the Main board is empty, you must writing the EDID again.
5. Troubleshooting.
5.1. Can’t write!
(1) AC on the monitor and turn on it.(Restart the monitor)
(2) Set the Burn in on last to try again.
To Next Page
Loading...
