Chapter 2 33
PnP/PCI Configuration
Parameter Option
Reset Configuration Data Disabled
Select Enabled to reset extended system configuration data(ESCD)
when you exit Setup if you have installed a new add-on and the
system reconfiguration has caused such a serious conflict that the OS
cannot boot.
Resource Controlled By Auto : Assign PnP resource (I/O address, IRQ& DMA channels) for
Plug and Play compatible devices automatically.
Manual : Assign resource manually
IRQ Resource When resource are controlled by manually, assign each system
interrupt a type, depending on the type of device using the interrupt.
PCI Device : Assign this IRQ for PCI device
Reserved : Reserve this IRQ for other device
PCI/VGA Palette Snoop Enabled : Enable PCI/VGA Palette Snoop function
Disabled : Disable this function
Phoenix - AwardBIOS CMOS Setup Utility
PNP/PCI Configuration
Resources Controlled By [Manual]
PCI/VGA Palette Snoop [Disabled]
Help Item
Menu Level X
Reset Configuration Data [Disabled]
X IRQ Resources [Press Enter]
F6:Load Optimized Defaults F7:Load Fail-Safe Defaults
KLIJ :Move Enter: Select +/-/ :Value ESC:Exit F1:General Help
To Next Page
Loading...
