Chapter 3 42
Disassembly Procedure
This section tells you how to disassemble the system when you need to perform system service. Please also
refer to the disassembly video, if available.
CAUTION: Before you proceed, make sure you have turned off the system and all peripherals connected to it.
Opening the System
1. Place the system unit on a flat, steady surface.
2. Turning the housing back, turn the three screws securing the side cover and remove them.
3. Slide the side door out.
Removing the Add-On Card (AS L300 only)
1. Release the screw securing the add-on card.
2. Remove the add-on card as shown.
Removing Cables
1. Disconnect the IDE connectors from the PCI riser card. (AS L300 only)
To Next Page
Loading...
