66 Chapter 3
Install the Optica Drive
1. Remove the front panel(Refer to “Removing the Front Bezel” on page 28).
2. Before install the optica drive, check the front panel frist whether there is the panel of ODD, if so, shall
panel of ODD disassembly from the front panel. At the same time, check ODD location whether there is
the sheet metal, if so, remove the sheet metal.
3. When prepare to install the optica drive, check the Lock handle whether open state. if not, open the Lock
handle.
4. Install master ODD and slave ODD into chassis.
To Next Page
Loading...
