23
2.2 When insert the USB cable to PC USB port, will pop up a Hardware Wizard to help you install the USB driver if you
use this ISP board first time.it can auto install success by itself
Remark: The USB driver files path: D:\FTC100103(Mstar)\FTCUSB.INF
After installation the USB serial port driver, please to check the port. Look the properties of “my Computer”.
3. Install the ISP tool.
Note: If the F/W Upgrade use the same ISP tool as the EDID writing, you must close the EDID writing tool
before running the F/W Upgrade tool.
3.1 Copy the three file in one folder.
3.2 Double-click to run the ISP tool.
To Next Page
Loading...
