Acer X34GS - Page 8

8
This LCD monitor includes an interface board, power board and a function key board. The interface board
controls the TFT panel control logic, brightness control logic, and DC-DC conversion to supply the appropriate
power to the whole board and LCD panel then transmitting LVDS signals into LCD Module to drive the LCD
display circuit. The power board will provide the DC power to the interface board and LCD panel. The function key
board is used for OSD control, monitor power ON/OFF and the LED indicator for power status.
ITEM
SPEC
HDMI (Digital Video Interface)
F r equency Ranges
H: 31KHz~151KHz V: 48Hz~100Hz
Max Pixel c l ock
550MHz MHz
Input Impedance
100
Ω
HDMI
HDMI 2.0
DP(Display Port)
F r equency Ranges
H: 271KHz - 271KHz V: 48Hz~180Hz
Max Pixel c l ock
960MHz
Input Impedance
100
Ω
DP
DP 1.4
Connectors
DC Jack
WAFER 2.5mm 4P 90' DIP
Input connecto r s
HDMI 19pinx2, DisplayPort 20-pin x 2 , Type-B 3.0 9-
pin x1, Type-C 12-pinx1, Type-A 18-pinx4
Power Consump ti on
100~240 Vac, 50~60Hz
180W(max)
Power Sav i ng
< 0.5W
Power Off
< 0.3W
User’s Co n t r o l
Buttons
POWER, hot key1, hot key2, input key, menu key
Dimm i n g control range (max-min/max) x 100%
100%
Pre-Defined Timing
Preset T i ming
15
User’s Timing
16
Plug and P l ay
VESA DDCCI
Power Sav i ng
DPMS
Display Color
8bit+A-FRC
Response Time
OD Off :5ms/Nomal:3ms/Extreme:1ms
VRB Off :depending on OD
Setting/Normal:3ms/Extreme:1ms
1.3.1 Interface Connectors:
1.3.1.1 AC SOCKET
The AC inlet connector shall be an IEC/CEE-22 type male power receptacle for connection to mains
power. The power cord shall be black with length of 1.9±0.05 meters. The power cord type is different
from regions.
1.3.1.2 Analog Connector and Cable: The analog signal cable shall be black and 1800 mini-meters. The
analog VGA cable shall be a molded-over, shielded, triple row, 15 pins and blue color D type connector.