- 11 -
05/ Fixture Installation
The fixture is IP66-rated and designed for both indoor and outdoor events. This means that it
is protected from:
Dust, to the degree that dust cannot enter the device in sufficient quantities as to
interfere with its operation.
Water jets from any direction.
DO install and operate by qualified operator. Fixture(s) should be installed in areas outside
walking paths, seating areas, or away from areas were unauthorized personnel might reach
the fixture by hand. NEVER stand directly below the fixture(s) when rigging, removing or
servicing.
Always ensure that the unit is firmly fixed to avoid vibration and slipping off during operation.
Ensure that the trussing or area of installation must be able to hold 10 times the weight
without any deformation. Always attach a safety cable that can hold at least 12 times the
weight of the fixture whenever installing this fixture in a suspended environment to ensure
that the fixture will not fall if the clamp fails.
This fixture is fully operational in two different mounting positions: hanging upside-down, or
standing on the floor. DO NOT mount this fixture sideways on trussing. Always use and
install a safety cable as a safety measure to prevent accidental damage and/or injury in the
event the clamp fails.
To Next Page
Loading...
