ACME SUPERNOVA - Page 20

- 19 -
DMX Settings
Enter the control menu and select DMX Settings, press ENTER. Use the UP/DOWN button
to select DMX Address, DMX Channel Mode, No DMX Status, View DMX Value, Connect
Option, Network, Art-Net Settings, sACN Settings or Network to DMX.
DMX Address
DMX Channel Mode
No DMX Status
Select No DMX Status, press ENTER.
Use UP/DOWN button to select one of the following status:
Blackout (Fixture blacks out if DMX signal stops)
Hold (The device continues to operate in the current mode with the last
active DMX values until the signal returns)
Manual (The device accepts the DMX value stored in the ‘Manual Test’
menu)
Confirm your selection with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
Select DMX Channel Mode, press ENTER.
Use UP/DOWN button to select between (43) Framing, (34) Spot, (32)
F-Wash and (23) Wash, confirm your selection with ENTER.
To exit the menu, press MENU, or wait 30 seconds.
Select DMX Address, press ENTER.
Use UP/DOWN button to select an address, confirm your selection with
ENTER.
CHANNEL MODE
DMX ADDRESS
(43) Framing
1-470
(34) Spot
1-479
(32) F-Wash
1-481
(23) Wash
1-490
To exit the menu, press MENU, or wait 30 seconds.