6.17
EVALUATING THE RESULT
The angle and offset values are used to
determine the alignment quality. These values
are compared with the alignment tolerances
to determine whether correction is necessary.
If suitable tolerances are selected in the
tolerance table, the symbols described above
indicate if the angle and offset values are
within tolerance or not.
The foot values indicate the movable
machine’s foot positions where corrections
can be made.
Depending on the result, the program will also
guide the user.
First, the program will always recommend the
user to save the measurement.
Then, if the measurement result shows that
the machine is misaligned, the user will be
recommended to go to shimming.
If the measurement result is within tolerance
and has been saved, the system will
recommend the user to exit the measurement.
To Next Page
Loading...