7.1
SHAFT ALIGNMENT
VERTICAL MACHINES
INTRODUCTION
Shaft alignment: Determine and adjust the
relative position of two machines that are
connected, such as a motor and a pump, so
that the rotational centers of the shafts are
collinear, when the machines are working at a
normal operating temperature. Correction of
vertical shaft alignment is done by moving the
flange of the machine until the shafts are
aligned within given tolerances. A tolerance
table is available in the system.
The EVO system has two measuring units
that are placed on each shaft by using the
fixtures supplied with the system.
To Next Page
Loading...