66
W A R N I N G HIGH VOLTAGE!
Both the mains voltage and the high DC voltage up to 500V
inside the ACOM 700S amplier are LETHAL! For your
safety, disconnect the power plug from the mains and WAIT
AT LEAST three minutes EACH TIME, BEFORE removing the
cover of the amplier.
W A R N I N G HIGH VOLTAGE!
NEVER ALLOW, ESPECIALLY CHILDREN, to insert anything
into holes in the case - this may cause ELECTRIC
SHOCK! Never touch an antenna or antenna isolators
during transmission or tuning - this may result in an
electric shock or burn. Never expose the amplier to rain,
snow or any liquids. Avoid placing the amplier in
excessively dusty environments or in direct sunlight. DO
NOT OBSTRUCT COOLING ducts or vents.
W A R N I N G
Do not undertake repairs or changes in hardware or rmware
of your ACOM 700S amplier. Doing so will endanger your
or others‘ health or life, or damage the amplier and
the equipment connected to it. Such repairs or changes
are not covered by the warranty and may void
the warranty. The manufacturer is not liable for any
such repairs or changes. Any such repairs or changes are
sole responsibility of the person or persons engaging in
them.
C A U T I O N
To avoid damage (not covered by the warranty) please read the
INSTALLATION - Section 2 of this operating manual carefully.
If you have any doubts or questions regarding the installation,
operation or safety of the ACOM 700S amplier, please consult
your dealer immediately.
2. INSTALLATION
2-1. Unpacking and Initial Inspection
C A U T I O N
Before you commence installing the ACOM 700S amplier,
please read this manual thoroughly. Carefully inspect the
shipping carton and its contents as described below for missing
items (S. 1-3) or mechanical damages. If anything is missing or
is damaged (scratched, bent, crushed or something is rattling
inside or moving freely when turning the amplier over, notify
your dealer immediately! Delaying this notication may infringe
the insurance conditions of the carrier.
To Next Page
Loading...
