Acom ACOM2100 - Page 5

5
W A R N I N G HIGH VOLTAGE!
The amplier works with high voltages above 3000V, which are LETHAL! Also,
for your safety, pull the amplier power plug out of the mains wall outlet and
WAIT AT LEAST 30 minutes EACH TIME BEFORE you remove the cover of the
amplier. Do not touch any part inside while the amplier is open because some
residual voltages may still be present.
W A R N I N G HIGH VOLTAGE!
NEVER ALLOW ANYONE, ESPECIALLY CHILDREN, to push anything into holes
in the case - this will cause electric shock. NEVER TOUCH AN ANTENNA during
transmission - this may result in an electric shock or burn. NEVER EXPOSE the
amplier to rain, snow or any liquids. AVOID placing the amplier in excessively
dusty environments or in direct sunlight. DO NOT OBSTRUCT AIR INTAKE
(rear panel) and EXHAUST (top cover) areas of the amplier. Keep a minimum
distance of 10cm (4 inches) to the intake and 50cm (20 inches) to the exhaust
openings.
W A R N I N G
Do not undertake your own repairs or changes in hardware or software of the
amplier. Doing so will endanger your or others' health or life or damage the
amplier and the equipment connected to it. Such repairs or changes are not
covered by warranty and may void the warranty. The manufacturer is not liable
for any such repairs or changes. Any such repairs or changes are strictly the
responsibility of the person or persons engaging therein.
C A U T I O N
To avoid damage (not covered under warranty) read the Installation - Section 2 of
this operating manual carefully. If you have any doubts or questions regarding the
installation, operation or safety of the amplier, please consult your dealer immediately.