Acom ACOM2100 - APPENDIX A: TRANSFORMER INSTALLATION; Transformer Mounting Procedure

22
C A U T I O N
After installing the transformer, the weight of the unit is about 30kg, which
should preferably be handled by two persons. An assistant may be needed
to hold the amplier steady during transformer installation.
Position the amplier, with the transformer not yet installed, at on a table near the place where
it will be used. During the process described below, when the amplier cover is removed, take
care not to torque or twist the chassis nor let the amplier stand on edge. Do not lift the unit by
only one corner.
Remove the cover by removing all nine M3x6 screws.
Orient the amplier on the table so that the transformer compartment is in front of you.
Unplug all ve connectors from the Mains board and remove two M3x8 screws and one M3x6
screw.
APENDIX A
ACOM 2100 TRANSFORMER INSTALLATION