ACTUATOR
MODE
7. The Handheld Programmer will briefly
confirm the new “ACTUATOR MODE”.
8. After confirmation, the Handheld
Programmer will return to the controller/
station screen. You can change the
“ACTUATOR MODE” for a new valve,
or press the “ESCAPE” button to change
a different feature.
How to change the Actuator Mode:
1. From the “PRESS YOUR DESIRED
FUNCTION KEY” screen, press the
“ACTUATOR MODE” button.
2. If you are connected to multiple controllers,
enter the controller address with the valve
you want to program and press “ENTER”.
If not, proceed to step #3.
3. Enter the station number of the valve you
want to program and press “ENTER”.
4. The Handheld Programmer will briefly
display the old mode.
5. Press the numerical value on the keypad
for the mode you require. See “Keypad
Definitions” for descriptions of each mode.
SC = Single Cycle Mode
CI = Cycle Interrupt Mode
AM = Accumulator Mode
TM = Terminate Cycle Mode
Technical Support: (800) 743-8259
www.acorneng.com
11
To Next Page
Loading...
Need help?
General