Service
Refer all servicing to qualified service personnel.
Servicing
is
required when the unit has been
damaged
in
any
way,
such
as
the power supply
cord or plug is damaged, liquid has been spilled on
or objects have fallen into the unit, the apparatus
has been exposed to rain or moisture, it does not
operate normally or it has been dropped.
Equipment for servicing should be returned to the
supplying dealer, or to the service agent for your
area.
FCC Statement (For US Customers)
This device complies with Part 15 of the
FCC
Rules.
Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference,
and
(2)
this device must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part
15
of the
FCC
Rules. These limits are
designed to provide reasonable protection against
harmful interference
in
a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur
in
a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by
turning the equipment off and on, the user
is
encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and
receiver.
• Connect the equipment into
an
outlet on a
circuit different from that to which the receiver
is
connected.
• Consult the dealer or
an
experienced radio/TV
technician for help.
CAUTION! Any changes or modifications made
to this device that are not expressly approved
by
the manufacturer may void the user's authority to
operate the equipment.
This equipment complies with
FCC
radiation
exposure limits set forth for
an
uncontrolled
environment. This equipment should be installed
and operated with minimum distance 20cm between
the radiator & your body.
2
Important notice for UK users
The UK mains lead
is
terminated with a UK approved
mains plug fitted with a
3A
fuse. If the fuse needs to
be replaced,
an
ASTA
or
BSI
approved BS1362 fuse
rated at 3A must be used.
Industry Canada Statement (for Canadian
Customers)
CAN
ICES-3 (B)/NMB-3(8)
The device meets the exemption from the routine
evaluation limits set out
in
section 2.5
of
RSS
102
and
is
in
full compliance with RSS-102
RF.
Users can
obtain information on
RF
exposure and compliance
from Industry Canada.
This device complies with Industry Canada licence-
exempt
RSS
standard(s). Operation is subject to the
following two conditions:
1.
This device may not cause harmful interference,
and
2.
This device must accept any interference
received, including interference that may cause
undesired operation.
To Next Page
Loading...