ACT ACTsmart2 Series - Page 6

ACTsmart2 Operating and Installation Manual Rev. 1.3
7
30 Second Programming Guide
ACTsmart2 Pin & Prox (1080)
(For typical Standalone System)
1. Enter Programming Mode.
Press
✘
button followed by the programming code (default is 9999)
The LED will flash amber.
2. Add a Batch of Cards
Press 10, then present the first card in the batch followed by the last card in the batch.
Press
✔ button to complete.
3. Add a PIN Code
Press 12, and then enter a 4-digit PIN code.
Press
✔ button to complete.
(Option 40 - Card or PIN.)
4. Set Desired Door Relay Active Time
Press 20, and then enter the desired number of seconds from 000-255 (three digits with
leading zeros). Press
✔ button to complete. The default time is 5 seconds.
5. Change Programming code
Press 23, then enter new 4-digit programming code. Press
✔
to complete
6. Exit Programming Mode
Press the
✘
button. The LED turns red.
The ACTsmart is now ready for normal use.
Note: The ACTsmart2 may be returned to its factory default condition at any time by entering the
programming mode and pressing 80 followed by the
✔ button.
For information on programming the advanced features and networking the ACTsmart2 range, please
refer to the complete programming guide.
Unit C1, South City Business Centre,
Tallaght, Dublin 24, Ireland.
Tel: 353-1-4662570 Fax: 353-1-4520427 UK Locall: 0845 300 5204
Web: http://www.accesscontrol.ie E-mail: sales@ accesscontrol.ie
Copyright © 2008 Access Control Technology Ltd.
ACTsmart2 Mar/Apr 08:ACTsmart2 Mar 08 29/04/2008 17:03 Page 7