EasyManua.ls Logo

ACT DTNVS - Operation in Salt Water Areas

ACT DTNVS
43 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ACTinBlack Europe S.à r.l. Rev 1.0, May 2020 20
3.7 Operation in Salt Water Areas:
After exposure to salt water, clean the unit as instructed in
this manual, after rinsing with fresh water.
3.8 Shutting Down the Unit:
Perform the following procedures to shut down the
Binocular.
1. Turn the Binocular power switch to the OFF position.
2. Remove the Binocular from the head mount or
helmet mount.
NOTE
It is recommended to turn the battery cap twist
counter-clockwise for one full turn to break the
electric circuit. This will preserve battery life if
device is not operating for long duration.
3.9 Preparation for Storage:
1. Remove battery from the Binocular.
2. Inspect the battery housing for corrosion or moisture.
Clean and dry if necessary.
3. Replace the battery cap.
4. Remove the demist shield or sacrificial window if
installed. Install objective lens cap or utilize bikini
covers.
NOTE
Prior to placing DTNVS into carrying case, ensure
DTNVS and case are free of dirt, dust, and
moisture.
5. Place the Binocular, accessories and cleaning
supplies back into their storage/carrying case.
It is best to place the items in their original
locations to prevent any possible damage to
the unit and/or accessories.
6. Return to storage area.