Acteon Sopro 617 - Sopro Imaging Software Installation

ENGLISH
7.4. SOPRO IMAGING SOFTWARE INSTALLATION
• Insert the SOPRO Imaging CD-ROM into the driver. It automatically executes.
WARNING:
NOTE:
NOTE:
To obtain better performance (if possible) when using the Imaging SOPRO software, it is recommended to
install DirectX 9.0c. In order to do this, click on the key “Install DirectX 9.0c” and then, follow the displayed
instructions. DirectX 9.0c is a Microsoft
®
product. In case of difficulties when installing this product, consult
the information provided by this editor.
In order to ensure maximal compatibility with all the installed systems (computers, Windows, and word
processing version) it was decided to provide the documents available on the CD-ROM in PDF format.
This format developed by ADOBE
®
Company can be read with the Acrobat Reader service program.
If Acrobat Reader is not installed on the computer or the version is not recent enough, click on the key
“Install Acrobat Reader” and then, follow the instructions. Acrobat Reader is an ADOBE
®
product. In case of
difficulties when installing this product, consult the information provided by this editor.
Clicking on the key “Browse this CD-ROM” allows access to a Windows browse window from which it is
possible to consult the whole content of the CD-ROM.
At the CD-ROM root, there are the files allowing the automatic launch and/or the manual setup.
- in the directory “Document” and its subdirectories, there are all the documents about the Imaging SOPRO
software and the Sopix system; these documents are in PDF format. Make sure to correctly install Acrobat
Reader in case of reading difficulties.
- the Drivers directories contain the drivers necessary to use the hardware accepted by SOPRO Imaging
(Sopix system, SOPRO cameras in USB 1 and USB 2, Hasp protection key).
- the directory SOPRO Imaging contains the SOPRO Imaging installation program.
- the directory “Tools” contains the Microsoft Direct X 9.0 c and ADOBE Acrobat Reader installation
programs.
If the CD-ROM does not automatically run or if the operating system is lower than Windows XP SP1, follow
the below instructions:
- Go to the Start menu > Execute.
- Type D:\setup.exe (replace D by the letter of the CD-ROM driver).
- And then, click on OK. The file instantly runs… then follow the steps from the below point.
Sopro 617 • User manual
14