Hardware Manual
15
Access the Camera
Before you begin, check that:
Your camera is operating properly and connected to the network.
The PC you are using is installed with Internet Explorer 11.
Follow these steps to access your camera through the Web:
1. Open your browser; input the IP address of your camera in the address bar and then press
Enter to open the login page.
2. Enter the username and password and then click Login.
The factory default Account and Password of the camera:
Account: Admin
Password: 123456
NOTE:
Install the ActiveX at your first login. When the installation of the ActiveX is completed,
open your IE to log in.
For your first login with Windows 7, if the system does not prompt you to install ActiveX,
follow these steps to turn off UAC: click the Start button, and then click Control Panel. In
the search box, type uac, and then click Change User Account Control Settings. Move
the slider to the Never Notify position, and then click OK. After UAC is turned off, log in
again.
If the installation failed, open Internet Option in IE before login. Click the Security tab,
click Trusted sites, and then click Sites to add the website. If you use Windows 7, you
need to save the setup.exe to your PC first, and then right-click the file, select Run as
administrator, and then install it according to instructions.
To Next Page
Loading...
