Hardware Manual
23
Access the Camera
Now that the camera and the PC are both having their unique IP addresses and are under the
same network segment, it is possible to use the Web browser of the PC to access the camera.
You can use Microsoft Internet Explorer to access the camera
When using Internet Explorer browser, the ActiveX control for video stream management will be
downloaded from the camera directly – the user just has to accept the use of such control when
prompted so. No other third party utilities are required to be installed in such case.
The following examples in this manual are based on Internet Explorer browser in order to
cover all functions of the camera.
Assuming that the camera’s IP address is 192.168.0.100, you can access it by opening the Web
browser and typing the following address into Web browser’s address bar:
http://192.168.0.100
Upon successful connection to the camera, the user interface called Web Configurator would
appear together with the login page. The HTTP port number was not added behind the IP address
since the default HTTP port of the camera is 80, which can be omitted from the address for
convenience.
You will be prompted with the default account and password. For Username, type “admin” and
for Password, type “123456”.
For Z710 and later models, when you login for the first time, you will be prompted to change the
administrator password. The password must be at least 9 characters. Follow the on-screen
instructions to do so. The image below is for reference only, actual on-screen prompt may vary
depending on the camera model.
To Next Page
Loading...
