43
Chapter 4 Using Advanced Setup
Netmeeting
If a computer on the network uses Netmeeting, enable Netmeeting by clicking the
circle next to “On” and entering the IP address of the computer. Click Next, then
click Save and Restart to apply the settings. If Netmeeting is not needed, click the
circle next to “Off.”
☞
Note: Netmeeting is used for NAT/Private IP addressing only. If
the computer is configured for Unnumbered Mode and has a
public IP address, Netmeeting does not have to be enabled.
Website Blocking
Selecting Website Blocking in the “Configuring the Advanced Settings” screen
generates the “Website Blocking” screen. This feature enables the Modem to block
Web sites to all computers on the network. To block a Web site, enter the address
of the Web site in the “Website” text box and click Add. The blocked Web site
address is displayed in the “Blocked Website List” text box, and will not be avail-
able to computers on the network. To remove a blocked Web site, click on it in the
“Blocked Website List,” then click Remove. Website Blocking supports blocking up
to 50 Web sites.
To Next Page
Loading...
Need help?
General
