47
Chapter 4 Using Advanced Setup
Dynamic Routing
Selecting Dynamic Routing in the “Configuring the Advanced Settings” screen
generates the “Dynamic Routing” screen.
If a router or gateway is set up behind the Modem in the network configuration,
consult the documentation that came with the router/gateway to see what kind of
Dynamic Routing is required operate it with the Modem, then select the appropri-
ate option in this screen.
NAT (Network Address Translation)
Selecting NAT in the “Configuring the Advanced Settings” screen generates the
“NAT” screen. The Modem’s basic firewall security is based on NAT. Disabling NAT
allows the computers connected to the Modem to be accessed by outside parties.
Do not turn NAT off unless instructed to do so by the ISP.
To Next Page
Loading...
Need help?
General
