4. Watch the Power and Sync LEDs of the device ash for 2-3 minutes.
Do not power down the device or remove the USB thumb drive while
the LEDs are ashing.
5. Aer the LEDs turn o briey, the Power LED will ash, then glow
solid green. When this occurs, remove the thumb drive from the
MyWirelessTV device.
6. Repeat steps 3-5 for all MyWirelessTV devices that need an update.
Once the rmware update has been applied to all MyWirelessTV devices,
perform a power cycle (turn o, then on) on all devices. e
MyWirelessTV devices will pair automatically, streaming audio and
video. Perform another power cycle on all devices. e rmware update
has been successfully applied.
MyWirelessTV User Manual
28
To Next Page
Loading...
