3. Select Prioritize Speed in the Quality vs. Speed section of the screen,
then click Apply Settings. Refer to Intel's support documentation for
more information.
!
USB over Network
e Receiver’s USB over Network (UoIP) feature allows the use of USB
HID peripheral devices, either from the source device or from the USB
device side. To connect a USB keyboard, mouse, or trackpad:
1. Use the ScreenBeam Conguration Utility to set the USB Local
Access to On, and then select UoIP or UIBC. Refer to Setting up USB
Local Access for details.
2. Plug the USB device into the Receiver’s USB port and wait for the
device to be detected. is may take 10-15 seconds.
3. Use the USB device (keyboard, mouse, or trackpad) to control the
source device.
Note: UoIP is compatible with Intel WiDi only.
!
To Next Page
Loading...
