ActionTec ScreenBeam SBWD100A - Updating Software and Firmware; Updating Software on Windows 7;8 Devices

To Next Page

To Previous Page

Updating Software

and Firmware

This chapter details the procedures to upgrade the ScreenBeam software and

firmware. The first section details updating the ScreenBeam software if you are

using ScreenBeam with a Windows 7/8 laptop/PC; the second explains how to

update the firmware on the ScreenBeam Display Receiver if you are using Miracast

or Intel WiDi.

Updating Software on Windows 7/8 Devices

This section explains how to update your ScreenBeam software if you are using

both the ScreenBeam Display Receiver and Transmitter with a Windows 7/8

laptop/PC.

1. Make sure that ScreenBeam is disconnected. Then, right-click on a profile

from the main ScreenBeam window and select “Check for updates…”

Note: Performing a software update may cause the ScreenBeam application

to restart. If this occurs, relaunch ScreenBeam after the update is completed.