21
Frequently Asked
Questions
This chapter lists a series of frequently asked questions concerning the operation of
the ScreenBeam components.
Note: Go to http://www.actiontec.com/screenbeam to access any FAQs created
or updated after the publication date of this manual.
Do I need to install ScreenBeam software or the USB Transmitter
included with the ScreenBeam Kit to connect to a Wi-Fi Miracast or Intel
WiDi device?
No. For Miracast devices, refer to the user guide of the device’s manufacturer. For
WiDi (3.5 and higher) laptops, make sure your system driver and WiDi software
are up-to-date.
Why can’t I see anything on my TV screen?
If you’re not getting a picture on your TV, make sure the ScreenBeam Receiver is
connected, powered on, and the correct TV input (HDMI 1, HDMI 2, etc.) has
been selected.
I’ve inserted the software CD into the CD-ROM drive, but it doesn’t
install. What should I do?
In Windows Explorer, browse to the CD-ROM drive (e.g., D:), then locate and
double-click on the “Setup.exe” file.
5
To Next Page
Loading...