11
5. Assembly Instructions (cont.)
5.5 Wallmount
5.6 Shelf Mounting Procedure
*A
*C
*B
STEP A-1
1. Use measuring tape to mark 2 drilling holes for
screws.
2. Drill on the marks using 5/16" drill bits to 2-3/4"
depth.
3. Nuts are pre-attached to the expansion bolts as
shown. Tighten nut until the expansion bolt is
extruded 3/4" away from metal cone.
STEP A-2
1. Remove hexagon nut, spring washer and one flat
washer away from expansion bolt.
2. Hang the machine align to the expansion bolt, put on
flat washer and spring washer on bolt respectively.
3. Fasten hexagon nuts and secure the machine on the
wall.
STEP C
1. Place the machine upside down and insert one
block underneath to support the motor. Unscrew
4 pcs bolts from motor and detach motor from
wallmount cage.
STEP B-1
1. Secure two pieces of 2"x4" wood planks
(recommended 28" long) horizontally as shown
above.
STEP B-2
2. Continue with step in assembly instruction to
mount the machine.
CAUTION
Keep hardware and rubber support for shelf mount
installation.
WARNING
Product is very heavy, it is required to secure shelf
on studs to avoid shelf falling of accidentally.
Assembly Instructions
GROUND
CONCRETE WALL
STEP A-1
STEP A-2
ANCHOR BOLT
5/16˝ 2˝
16˝
45˝– 65˝
2¾˝
3/4˝
MACHINE
FLAT
WASHER
SPRING
WASHER
HEX NUT
45˝– 60˝
7˝
24˝
16˝
1/5˝
GROUND
WOOD STUD
For 24" spacing between studsFor concrete wall in the garage
2. Drill 4- 11 mm holes on the shelf according to
the dimensions provided.
3. Place motor & pump assembly on the shelf
through 2 pcs rubber pad and align with 4 holes,
f
asten 4 pcs bolt & nut set securely on shelf.
To Next Page
Loading...
