8
5. Assembly Instructions (cont.)
5.4 Assembly (cont.)
Plug GFCI into power receptacle. Firmly press and release
the TEST button, then press and release the RESET button.
The light on the GFCI should be illuminated.
RESET
TEST
5
WARNING
Make sure your hands are dry. Plug the unit into an outlet.parts.
Assembly Instructions
1
3
6
2
4
Attach high-pressure hose to the gun and the
pump outlet (hand tighten only, do not use any
tape to secure connections). Ensure the hose
adapter to the pressure washer pump outlet is
a m22-14mm connection!
Connect garden hose to the inlet adapter.
(hand tighten only)
Release the safety trigger if it is locked.
Attach garden hose to water supply and turn
water on.
Attach the desired spray tip to the wand and
the wand to the pressure washer gun. secure
tightly (hand tighten only)
NOTE
High pressure hose can be an M22-14mm
hose of any length. Recommended hose
diameters are 3/8 and 1/4 inch
NOTE
Provided nozzles orifice size is 3.7
(Recommended aer market nozzles are
between 3.5 and 4.0)
The gun if possess a threaded connection
should be m22-14mm to pressure hose
To Next Page
Loading...
Need help?
General
