6
Electrical Requirements for 120 volt installation only
• To use a 120 volt plug, be sure to locate the unit within 6 ft. of a standard 120 volt grounded outlet.
Use of an extension cord is not recommended due to safety considerations.
• Install a US “B” UL approved plug onto the blunt cord.
• Hardwiring Requirements (All units)
NOTE: Permanent wiring of the unit into your HVAC system must be done by a licensed HVAC installer
or electrical contractor only.
For 120V domestic units: Black = L1, White = Neutral, Green = Ground
For commercial units: Black = L1, White = L2, Green = Ground
For International Units: Brown = L1, Blue = L2, Green w/yellow stripe = Ground
ELECTRICAL REQUIREMENTS
Wiring of the unit into your HVAC system should be done by a licensed HVAC
installer or electrical contractor only
CAUTION
To Reduce the Risk of Electric Shock – DO NOT use in wet or damp locations.
This equipment emits UV-C radiation. DO NOT locate equipment in any
location allowing direct line-of-sight to vents, returns, or other duct openings.
Disconnect from supply before servicing or replacing.
WARNING
To Next Page
Loading...
