17
Problem Possible Solution
Inaccurate
temperature or
humidity
• Make sure both the display and 5-in-1 sensor are
placed away from any heat sources or vents
(see page 10).
• Make sure both units are positioned away from
moisture sources (see page 10).
• Make sure 5-in-1 sensor is mounted at least 5 ft (1.5
meters) off of the ground.
• Calibrate indoor and outdoor temperature and
humidity (see page 19).
No rainfall
• Check to ensure the rain gauge stabilizer (plastic tab)
has been removed from the bottom of the sensor (see
page 7).
• Clear debris, such as leaves, out of the rain collector
funnel and debris screen.
• Calibrate the Rain Gauge (see page 20).
Inaccurate wind
readings
• What is wind reading being compared to? Pro
weather stations are typically mounted at 30 ft
(10 meters) high or more. Make sure to compare
data using a sensor positioned at the same mounting
height.
• Check location of the sensor. Ensure it’s mounted
a minimum of 5 ft (1.5 meters) in the air with no
obstructions around it (within several feet).
• Ensure wind cups are spinning freely. If they hesitate
or stop try lubricating with graphite powder or spray
lubricant.
Display screen
not working
• Check that the power adapter is plugged into the
display and an electrical outlet.
• Check that the batteries are installed correctly.
Batteries may need to be replaced.
• Reset the display by pressing and holding the Reset
button, located in the battery compartment of the
display. Date and time will need to be entered after
a reset.
Troubleshooting
To Next Page
Loading...
