＋
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.
Snap the two halves of the keypad,
then install the parts in reverse
order.
Place a cloth on the edge of the
keypad, and remove the upper half
by carefully prying on the edge
with a small flat-tip screwdriver.
Remove the old battery and note
the polarity. Make sure the
polarity of the new battery is the
same ( side facing down), then
insert it in the keypad.
4.
5.
3.
Remote Transmitter
Instruments and Controls
129
BATTERY
An improperly disposed of battery can
be harmf ul to the environment and
human health.
Always conf irm local regulations f or
battery disposal.
０８／０２／０６ ２０：４５：２３ ３１ＴＬ１６００ ０１３４
To Next Page
Loading...
Need help?
General
