Acura 2009 TSX User Manual

In the HI setting, the heater turns off
when the seat gets warm, and turns
back on after the seat’s temperature
drops.
In the LO setting, the heater runs
continuously. It does not cycle with
temperature changes.
Follow these precautions whenever
you use the seat heaters:
If the engine is left idling for an
extended period, do not use the
seat heaters even on the LO
setting. It can weaken the battery,
causing hard starting.
Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current from the
battery.
Both front seats are equipped with
seat heaters. Because of the sensors
for the side airbag cutoff system,
there is no heater in the passenger’s
seat-back. The ignition switch must
be in the ON (II) position to use the
heaters.
Push the front of the switch, HI, to
rapidly heat up the seat. After the
seat reaches a comfortable
temperature, select LO by pushing
the back of the switch. This will keep
the seat warm.
Seat Heaters
Instruments and Controls
141
Passenger’s
Seat
Driver’s
Seat
HEATERS
SEAT HEATER SWITCH
０８／０２／０６ ２０：４７：１８ ３１ＴＬ１６００ ０１４６

Acura 2009 TSX Specifications

General

Brand	Acura
Model	2009 TSX
Category	Automobile
Language	English