If Honda MTF is not available, you
may use an SAE 10W-30 or 10W-40
viscosity motor oil with the API
Certification seal that says ‘‘FOR
GASOLINE ENGINES’’ as a
temporary replacement. However,
motor oil does not contain the proper
additives, and continued use can
cause stiffer shifting. Replace as
soon as it is convenient.Remove the transmission filler bolt,
and carefully feel inside the bolt hole
with your finger.
The fluid level should be up to the
edge of the bolt hole. If it is not, add
Honda Manual Transmission Fluid
(MTF) until it starts to run out of the
hole. Reinstall the filler bolt, and
tighten it securely.
Check the fluid level with the
transmission at normal operating
temperature and the vehicle sitting
on level ground.
The transmission should be drained
andrefilledwithnewfluidwhenthis
service is shown on a maintenance
message in the multi-information
display.
If you are not sure how to check and
add fluid, contact your dealer.
To check the transmission fluid level,
remove the bolts with a wrench, then
remove the under cover carefully.
Reinstall the under cover and tighten
theboltssecurely.Makesurethe
under cover is installed under the
edge of the front bumper.
Transmission Fluid
Manual Transmission
Maintenance
427
Correct level
FILLER BOLT
BOLT UNDER COVER
０８／０２／０６ ２１：３４：３８ ３１ＴＬ１６００ ０４３２
To Next Page
Loading...
Need help?
General
