The system will move the driver’s
seat to the memorized position. The
indicator in the selected memory
button will flash during movement.
When the adjustment is complete,
you will hear two beeps, and the
indicator will stay on.
Not press a memory button within
5 seconds.
Each memory button stores only one
driving position. Storing a new
position erases the previous setting
stored in that button’s memory. If
you want to add a new position while
retaining the current one, use the
other memory button.
To select a memorized position, do
this:
Doing any of the following after
pressing the SET button will cancel
the storing procedure.
Readjust the seat position.
Turn the ignition switch out from
the ON (II) position.
Make sure the parking brake is set
and the shift lever is in Park
(automatic).
If the parking brake is not set, you
must press and hold the memory
button until the adjustment is
complete.
Press the desired memory button
(1 or 2) until you hear a beep, then
release the button.
1.
2.
On vehicles with manual transmission
CONTINUED
Selecting a Memorized Position
Driving Position Memory System
Instruments and Controls
143
MEMORY BUTTONS
０８／０２／０６ ２０：４７：４０ ３１ＴＬ１６００ ０１４８
To Next Page
Loading...
Need help?
General
