The band and frequency that the
radio was last tuned to are shown on
the display. To change bands, press
the FM/AM button. You can also
change bands by pushing the
interface selector up. Each time you
push it up, the band will change to
FM1, FM2, or AM. On the FM bands,
STEREO will be shown on the
navigation screen and ST on the
center display, if the station is
broadcasting in stereo. Stereo
reproduction on AM is not available.
On the AM band, AM noise
reduction turns on automatically.
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Press the AUDIO button to
view the audio control display. Turn
the system on by pressing the
VOL/ knob or the FM/AM
button. Adjust the volume by turning
the VOL/ knob.
You can use any of five methods to
find radio stations on the selected
band: tune, skip (seek), scan, the
preset buttons, and auto select.
On the FM band, you can also use
the features provided by the radio
data system (RDS). For more
information on the RDS, see page
.227
To Play the FM/AM Radio To Select a Station
Playing the FM/AM Radio (Models with navigation system)
224
STEREO ICON
BAND
０８／０２／０６ ２１：００：３３ ３１ＴＬ１６００ ０２２９
To Next Page
Loading...
Need help?
General
