This feature, when activated, replays
all files on the selected folder. To
activate folder repeat mode, select
FOLDER REPEAT by interface
knob, and press ENTER on the
interface selector. You will see
REPEAT next to FOLDER on the
screen. To turn this feature off,
highlight FOLDER REPEAT (if not
already highlighted), and press
ENTER on the interface selector
again.
Toselectanytypeoftherepeat
modes,usetheinterfacedial.For
more information, see page .
This feature, when activated,
samples the first file of each folder
for 10 seconds. To scan a folder,
press the SCAN side of the SCAN/
A. SEL bar repeatedly. You will see
SCAN next to FOLDER and the
folder number blinking.
To listen to the rest of the folder,
press and hold the SCAN side of the
bar until you hear a beep. If you do
not, the system advances to the next
folder, plays 10 seconds of it, and
continues throughout the rest of the
folder in the same way. When the
system samples the first file of all
folders, folder scan is canceled, and
the last file played continues to play.
If the main folder has some
additional folders in the lower layer,
you can also see each lower folder
listedonthescreen.
You can see the list of all the files in
the selected folder. Turn the selector
knob, then press ENTER to set your
selection.
249
Folder RepeatFolder Scan
Playing Discs (Models with navigation system)
Features
253
CURRENT TRACK
０８／０２／０６ ２１：０５：２８ ３１ＴＬ１６００ ０２５８
To Next Page
Loading...
