In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone, do this:
Once the correct zone is displayed,
press the selector knob. The
display then returns to normal.
Turn the ignition switch to the ON
(II) position.
Turn the selector knob to select
‘‘ZONE.’’ Press the selector knob
(ENTER) to enter your selection.
The display shows you the
currently selected zone number.
Find the zone for your area on the
map (see page ). If the correct
zone is not shown, turn the
selector knob to cycle the zone
lists up or down.
If necessary, press the RETURN
button to return to the previous
display. Pressing the MENU
button will cancel the compass
setting mode.
Press and hold the MENU button
for about 5 seconds. The display
shows you the compass setting
menu items.
4. 5.
1.
2.
3.
298
CONTINUED
Compass Zone Selection
Compass
Features
297
ZONE NUMBER
０８／０２／０６ ２１：１２：３０ ３１ＴＬ１６００ ０３０２
To Next Page
Loading...
Need help?
General
