−
The default setting is prompt. When
a diagnostic info message appears,
and you select the Check Now option,
the system will prompt you before
connecting to the Acura server. If
you do not wish to connect at that
time, select No at the prompt, and
you will see the information from the
onboard database. The ‘‘Auto’’
setting will remove the prompt when
you select the Check Now option and
will automatically connect to the
Acura server. This setting only
applies when you have a Bluetooth
enabled phone that is paired with the
HFLandyouhavecompletedthe
Phone-Data Connection setup.
To find more information on
Bluetooth
compatible and enabled
cell phones, visit
or call
the HandsFreeLink
consumer
support at 1-888-528-7876. In Canada,
visit , or call 1-888-9-
ACURA-9.
www.acura.com/handsfreelink
www.acura.ca
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment.
Connect to the Acura Server
AcuraLink (U.S. models only)
352
０８／０２／０６ ２１：２２：２８ ３１ＴＬ１６００ ０３５７
To Next Page
Loading...
Need help?
General
